Zinc alloy die casting die from China manufacturer is a precision casting method that uses high pressure to force metal melt into a metal mold with complex shapes. It is a precision casting method. So what needs to be paid attention to when it is on the mold?
1. The installation position needs to meet the design requirements. It is necessary to minimize the expansion force of the mold and the center distance of the die-casting machine as much as possible, so that the force of the large bar can be uniform; regularly check the force error of the large bar , it needs to be adjusted if necessary.
2. Before installing the mold, we need to clean the equipment and the installation surface of the mold, check whether the length of the ejector bar is appropriate, check whether the length is equal, and check that the number of ejector bars should not be less than four. The pressure plate needs to have sufficient strength and precision to avoid loosening during use. For large molds, a mold bracket needs to be used, so that the mold can be prevented from sinking, dislocation or falling during use.

3. The cooling water pipe and installation need to be sealed, and the movement and setting of the mold need to be adjusted to an appropriate distance. When the equipment is shut down, put the mold into the preheater. Then set the holding furnace to the specified temperature and configure the specified capacity.
The above is an introduction to some knowledge that Zinc alloy die casting die from China manufacturer needs to pay attention to when casting molds.